| 1962 United States Tri-Service aircraft designation system | |
|---|---|
| Prior to the 1962 tri-service designation system, the F-4 Phantom II was designated F4H by the U.S. Navy, and F-110 Spectre by the U.S. Air Force. |
The 1962 United States Tri-Service aircraft designation system is a unified designation system introduced by the United States Department of Defense on 18 September 1962 for all the U.S. military aircraft. Prior to this date, each armed service used their own nomenclature system. Under the 1962 system, almost all aircraft receive an unified designation, whether operated by the United States Air Force (USAF), United States Navy (USN), United States Coast Guard (USCG), United States Marine Corps (USMC), or the United States Army. Experimental aircraft operated by manufacturers or National Aeronautics and Space Administration] (NASA) are also often assigned numbers in the X-series.[1]
The 1962 system was based on the one used by the USAF between 1948 and 1962. Since it was introduced, the 1962 system has been modified and updated; in 1997 a revised form of the system was released.[2]
Contents |
The designation system produces a Mission-Design-Series (MDS) designation of the form:
Of these components, only the Basic Mission, Design Number and Series Letter are mandatory. In the case of special vehicles a Vehicle Type symbol must also be included.
The vehicle type element is used to designate the type of aerospace craft. Aircraft not in one of the following categories (most fixed-wing aircraft) are not required to carry a type designator. The type categories are:
A UAV Control Segment is not an aircraft, it is the ground control equipment used to command a UAV. Only in recent years has an aircraft been designated as a spaceplane, the proposed MS-1A.
These prefixes are attached to aircraft not conducting normal operations, such as research, testing and development. The prefixes are:
A temporary special test means the aircraft is intended to return to normal service after the tests are completed, while permanent special test aircraft are not. The Planning code is no longer used but was meant to designate aircraft "on the drawing board". For example, using this system an airframe such as the F-13 could have initially been designated as ZF-13 during the design phase, possibly XF-13 if experimental testing was required before building a prototype, the YF-13; the final production model would simply be designated F-13 (with the first production variant being the F-13A). Continuing the example, some F-13 during their service life may have been used for testing modifications or researching new designs and designated JF-13 or NF-13; finally after (many) years of service, the airframe would be permanently grounded due to safety or economic reasons as GF-13.
All aircraft are to be assigned a basic mission code. In some cases, the basic mission code is replaced by one of the modified mission codes when it is more suitable (e.g., MH-53 Pave Low III). The defined codes are:
The rise of the multi-role fighter in the decades since the system was introduced has created some confusion about the difference between attack and fighter aircraft. According to the current designation system, an attack aircraft (A) is designed primarily for air-to-surface missions (also known as "attack missions"),[3] while a fighter category F incorporates not only aircraft designed primarily for air-to-air warfare, but—additionally—multipurpose aircraft[4] designed also for attack missions. The Air Force, supposedly because of unpopularity of battlefield attacks in its ranks, has even assigned the F designation to attack-only aircraft,[5] such as the F-111 Aardvark and F-117 Nighthawk; presently, its only A designated aircraft is the A-10 Thunderbolt II.
Of these code series, no normal aircraft have been assigned a K or R basic mission code in a manner conforming to the system.
Aircraft which are modified after manufacture or even built for a different mission to the standard airframe of a particular design are assigned a modified mission code. They are:
The multi-mission and utility missions could be considered the same thing, however they are applied to multipurpose aircraft conducting certain categories of mission. M-aircraft conduct combat or special operations while U-aircraft conduct combat support missions, such as transport (e.g., UH-60) and electronic warfare (e.g., MC-12). The vast majority of U.S. Coast Guard air assets include the H-code (e.g., HH-60 Jayhawk or HC-130 Hercules).
According to the designation system, aircraft of a particular vehicle type or basic mission (for manned, fixed-wing, powered aircraft) were to be numbered consecutively. Numbers were not to be assigned to avoid confusion with other letter sequences or to conform with manufacturers' model numbers. Recently this rule has been ignored, and aircraft have received a design number equal to the model number (e.g., KC-767A[1]) or have kept the design number when they are transferred from one series to another (e.g., the X-35 became the F-35).
Different versions of the same basic aircraft type are to be delineated using a single letter suffix beginning with "A" and increasing sequentially (skipping "I" and "O" to avoid confusion with the numbers "1" and "0"). It is not clear how much modification is required to merit a new series letter, e.g., the F-16C production run has varied extensively over time. The modification of an aircraft to carry out a new mission does not necessarily require a new suffix (e.g., F-111Cs modified for reconnaissance are designated RF-111C), but often a new letter is assigned (e.g., the UH-60As modified for Search and Rescue missions are designated HH-60G).
Since the 1962 system was introduced there have been a number of non-systematic aircraft designations and skipping of design numbers.
The most common changes are to use a number from another series, or some other choice, rather than the next available number (117, 767, 71). Another is to change the order of the letters or use new acronym based letters (e.g. SR) rather than existing ones. It should be noted that since the DOD has final authority over its own rules, even non-systematic designations are both correct and official. In other words, even though it uses the system as its guideline for naming aircraft, it can approve whatever it chooses, and whatever is approved is "correct".
The design number "13" has been skipped in many mission and vehicle series for its association with superstition. Some numbers were skipped when a number was requested and/or assigned to a project but the aircraft was never built. More information on the reasons behind the apparent skipping of design numbers can be found at Andreas Parsch's "Missing" USAF/DOD Aircraft Designations page.
The following design numbers in the 1962 system have been skipped:
| Mission or Vehicle Series | Missing numbers | Next available number |
|---|---|---|
| A | 8, 11 | 13 or 14 |
| B | 3 | |
| C | 16, 30, 34, 36, 39, 42–44 | 47 |
| D (Ground) | 3 | |
| E | 7 | 12 |
| F | 19, 24–34 | 24 or 36* |
| G | 16 | |
| H | 42, 49, 69 | 73 |
| K | n/a (K series was cancelled) | |
| L | 2 | |
| O | 6 | |
| P | 1, 6 | 9 |
| Q | 12, 13 | 19 |
| R | 2 | |
| S (ASW) | 1 | 4 |
| S (Spaceplane) | Possibly 2 | |
| T | 4, 5, 50 | 54 |
| U | 12, 14, 15 | 29 |
| V | 14, 17, 19, 21 | 24 |
| X | 23, 39, 52** | 56 |
| Z | 4 |
*: 24 or 36 depends on future aircraft designations of the DoD.
**: The X-23 and X-39 designations exist, but were never officially assigned. X-52 was skipped to avoid confusion with the Boeing B-52.
From 1939 a manufacturers code was added to designations to easily identify the manufacturer and the production plant.[11] The code was a two letters for example F-15E-50-MC the MC being the code for the McDonnell Douglas plant at St. Louis, Missouri.
In 1941 block numbers were added to designations to show minor equipment variations between production blocks.[12] The block number appears in the designation between the model suffix and manufacturers code (for example F-100D-85-NH).[12] Initially they incremented in numerical order -1, -2 , -3 but this was changed to -1, -5, -10, -15 in increments of five.[12] The gaps in the block numbers could be used for post-delivery modifications, for example a F-100D-85-NH could be modified in the field to F-100D-86-NH.[12] Not all types have used block numbers.